Busy. Please wait.
Log in with Clever
or

show password
Forgot Password?

Don't have an account?  Sign up 
Sign up using Clever
or

Username is available taken
show password

Your email address is only used to allow you to reset your password. See our Privacy Policy and Terms of Service.


Already a StudyStack user? Log In

Reset Password
Enter the associated with your account, and we'll email you a link to reset your password.

Final Exam

Quiz yourself by thinking what should be in each of the black spaces below before clicking on it to display the answer.
        Help!  

1
5
show 192.168.9.254 192.168.10.1 192.168.10.2 192.168.11.254 192.168.11.252  
🗑
Q: Which three statements characterize the transport layer protocols? (Choose three.)   show
🗑
Q: What is the purpose of ICMP messages?   show
🗑
show connectivity between a PC and the default gateway connectivity between two adjacent Cisco devices physical connectivity of a particular PC and the network the TCP/IP stack on a network host connectivity between two PCs on the same network  
🗑
show It notifies the sending host that the frame cannot be delivered. It initiates an ARP request. It forwards the frame out of all ports except for the port at which the frame was received. It broadcasts the frame out of all ports on the switch.  
🗑
show It places information in the frame that allows multiple Layer 3 protocols to use the same network interface and media. It provides delimitation of data according to the physical signaling requirements of the medium. It defines software pro  
🗑
Q: On which switch interface would an administrator configure an IP address so that the switch can be managed remotely?   show
🗑
A engineer is measuring the transfer of bits. He notices that the network throughput appears lower than the bandwidth expected. Which three factors could influence the differences in throughput? (Choose three.)   show
🗑
show service password-encryption login block-for 60 attempts 5 within 60 banner motd $Max failed logins = 5$ exec-timeout 30  
🗑
Q: Which two statements correctly describe a router memory type and its contents? (Choose two.)   show
🗑
Q: Which two components are necessary for a wireless client to be installed on a WLAN? (Choose two.)   show
🗑
Q: Open the PT activity. Perform the tasks in the activity instructions and then fill in the blank.   show
🗑
show applying security settings to control the flow of data notifying other devices when errors occur regenerating data signals acting as a client or a server serving as the source or destination of the messages  
🗑
show Copper Cables Horizontal Cabling Structure desktop PCs in an enterprise office Fiber Optic Backbone cabling in an enterprise long-haul networks Wireless Guest access in a coffee shop Waiting rooms in a hospital  
🗑
Q: What is the correct order for PDU encapsulation?   show
🗑
show IP address logical address MAC address default gateway address  
🗑
show The host will have to use ARP to determine the correct address of the default gateway. The host cannot communicate with other hosts in the local network. The host cannot communicate with hosts in other networks.  
🗑
show DHCPREQUEST DHCPOFFER DHCPDISCOVER DHCPNACK DHCPACK  
🗑
Q: Refer to the exhibit. An administrator wants to change the name of a brand new switch, using the hostname command as shown. What prompt will display after the command is issued? Switch(config)# hostname My Switch   show
🗑
Q: After making configuration changes, a network administrator issues a copy running-config startup-config command in a Cisco switch. What is the result of issuing this command?   show
🗑
Q: Refer to the exhibit.A TCP segment from a server has been captured by Wireshark, which is running on a host. What acknowledgement number will the host return for the TCP segment that has been received?   show
🗑
show ARP DNS SMB DHCP HTTP NAT  
🗑
Q: 23 What is the purpose of the routing process?   show
🗑
show audio conference, financial transactions, web page financial transactions, audio conference, web page audio conference, web page, financial transactions financial transactions, web page, audio conference  
🗑
show cell modem dial-up cable modem satellite DSL  
🗑
Q: Which connection provides a secure CLI session with encryption to a Cisco switch?   show
🗑
Q: What is the purpose of the network security accounting function?   show
🗑
Q: Refer to the exhibit. A network administrator is configuring access control to switch SW1. If the administrator uses Telnet to connect to the switch, which password is needed to access user EXEC mode?   show
🗑
show IEEE standards Request for Comments IRTF research papers protocol models  
🗑
show This entry refers to the PC itself. This entry maps to the default gateway. This is a static map entry. This is a dynamic map entry.  
🗑
Q: Which subnet would include the address 192.168.1.96 as a usable host address?   show
🗑
show ipconfig /all ipconfig /displaydns arp -a nslookup  
🗑
show WPA PSK WEP EAP  
🗑
Q: A frame is transmitted from one networking device to another. Why does the receiving device check the FCS field in the frame?   show
🗑
Q: Refer to the exhibit. Which IP addressing scheme should be changed?   show
🗑
Q: What is the effect of configuring the ipv6 unicast-routing command on a router?   show
🗑
show 10.1.1.1 172.16.4.4 224.6.6.6 192.168.5.5 172.32.5.2 192.167.10.10  
🗑
show It is the IP address of the ISP network device located in the cloud. It is the IP address of Switch1 that connects PC1 to other devices on the same LAN. It is the IP address of the Router1 interface that connects the PC1 LAN to Router1.  
🗑
show flash RAM NVRAM disk drive  
🗑
show It encodes frames into electrical, optical, or radio wave signals. It accepts frames from the physical media. It encapsulates upper layer data into frames. It defines the media access method performed by the hardware interface.  
🗑
Q: Which procedure is used to reduce the effect of crosstalk in copper cables?   show
🗑
Q: What are the three primary functions provided by Layer 2 data encapsulation? (Choose three.)   show
🗑
Q: What method is used to manage contention-based access on a wireless network?   show
🗑
Q: What happens when part of an Internet radio transmission is not delivered to the destination?   show
🗑
Q: What is the auto-MDIX feature on a switch?   show
🗑
Q: Which function is provided by TCP?   show
🗑
Q: How does a Layer 3 switch differ from a Layer 2 switch?   show
🗑
show /68 /62 /66 /64 /70  
🗑
Q: What is the purpose of having a converged network?   show
🗑
Q: Refer to the exhibit. A ping to PC3 is issued from PC0, PC1, and PC2 in this exact order. Which MAC addresses will be contained in the S1 MAC address table that is associated with the Fa0/1 port?   show
🗑
Q: Which field in an IPv4 packet header will typically stay the same during its transmission?   show
🗑
Q: What two preconfigured settings that affect security are found on most new wireless routers? (Choose two.)   show
🗑
show the lower metric value that is associated with the destination network the higher gateway IP address to get to the destination network the lower gateway IP address to get to the destination network  
🗑
Q: Refer to the exhibit. What is the significance of the asterisk (*) in the exhibited output?   show
🗑
Q: Match the phases to their correct stage in the router bootup process.   show
🗑
Q: Fill in the blank. During data communications, a host may need to send a single message to a specific group of destination hosts simultaneously. This message is in the form of a ________ message.   show
🗑
show to interrupt the ping process to restart the ping process to allow the user to complete the command to exit to a different configuration mode  
🗑
show area A area D area C area B  
🗑
Q: Match the IPv6 address to the IPv6 address type:   show
🗑
Q: Match the description with the appropriate IOS mode.   show
🗑
show setup mode, NVRAM, TFTP NVRAM, TFTP, setup mode NVRAM, RAM, TFTP TFTP, ROM, NVRAM flash, ROM, setup mode  
🗑
show 2001:db8:abc:1::1 2001:db8:abc:5::1 2001:db8:abc:5::2 2001:db8:abc:10::15 (only one to end in 5:1)  
🗑
show physical address data error detection* logical address  
🗑
Q: Match each description with the corresponding TCP Mechanism   show
🗑


   

Review the information in the table. When you are ready to quiz yourself you can hide individual columns or the entire table. Then you can click on the empty cells to reveal the answer. Try to recall what will be displayed before clicking the empty cell.
 
To hide a column, click on the column name.
 
To hide the entire table, click on the "Hide All" button.
 
You may also shuffle the rows of the table by clicking on the "Shuffle" button.
 
Or sort by any of the columns using the down arrow next to any column heading.
If you know all the data on any row, you can temporarily remove it by tapping the trash can to the right of the row.

 
Embed Code - If you would like this activity on your web page, copy the script below and paste it into your web page.

  Normal Size     Small Size show me how
Created by: TheRobe81