Framing/Structure
Help!
|
|
||||
|---|---|---|---|---|---|
| In order for a Nail to properly join two pieces of wood, ____________ of the nail must drive into the base | show 🗑
|
||||
| In order to seal the bottom of a sill plate, it is sometimes required to use a | show 🗑
|
||||
| show | 4 feet
🗑
|
||||
| How tall must a Foundation cripple wall be to not require SOLID backing? | show 🗑
|
||||
| Any Habitable space should have a minimum ceiling height of | show 🗑
|
||||
| show | 70 square feet
🗑
|
||||
| Every dwelling unit should have at least ONE room that is at least _______ square feet | show 🗑
|
||||
| What part of a Floor or Ceiling Joist may NOT be cut or notched | show 🗑
|
||||
| show | 12 inches
🗑
|
||||
| A Floor Joist must be pressure treated if it is within _______ of the ground | show 🗑
|
||||
| show | 6 inches
🗑
|
||||
| Floor Joists must lap at least _______ on top of any wall, beam, or girder | show 🗑
|
||||
| show | 1 sq feet of venting per 150 sq feet of floor area
🗑
|
||||
| How large must the access hole be for the crawl space? | show 🗑
|
||||
| Standard nailing schedule for sub-floor? | show 🗑
|
||||
| All plywood sub-flooring must have SOLID backing unless you use | show 🗑
|
||||
| What is the maximum amount of notch in a joist? | show 🗑
|
||||
| show | 2 inches
🗑
|
||||
| show | 5/8 inches
🗑
|
||||
| A bored hole through the weight bearing stud can be no more than ________ of the stud depth | show 🗑
|
||||
| A bored hole through a non-bearing stud can be no more than _______ of the stud depth | show 🗑
|
||||
| show | 36 inches
🗑
|
||||
| show | 4.5 inches
🗑
|
||||
| What is the lowest allowed rise and the highest allowed rise on a private staircase | show 🗑
|
||||
| What is the lowest allowed run for a private staircase | show 🗑
|
||||
| What is the lowest allowed run for a private staircase without nosing | show 🗑
|
||||
| The largest tread width or riser will not exceed the smallest by more than ________ on a staircase | show 🗑
|
||||
| show | 3/4 inch - 1 1/4 inch
🗑
|
||||
| Open risers are allowed ONLY if a _______ cannot fit through the openings | show 🗑
|
||||
| show | 6 foot 8 inches
🗑
|
||||
| show | Garages and under stair-ways
🗑
|
||||
| show | as wide as the door and at least 36 inches long
🗑
|
||||
| show | 4
🗑
|
||||
| What is the minimum clearance between the handrail and wall | show 🗑
|
||||
| show | 34 to 38 inches
🗑
|
||||
| What are the allowed stair handrail diameters? | show 🗑
|
||||
| show | 4-6 1/4" perimeter with no more than 2 1/4" cross section
🗑
|
||||
| Any open sides of stairways, landings, balconies, decks etc. more than _______ above grade require gaurdrails | show 🗑
|
||||
| The tops of guardrails must be at least _______ above the standing surface | show 🗑
|
||||
| No where on a gaurdrail may a _________ pass through any opening | show 🗑
|
||||
| show | 42 inches from standing surface, 4 3/8" sphere cant pass through vertical guards, 6" sphere cant pass through bottom gaurds
🗑
|
||||
| show | Gambrel Roof
🗑
|
||||
| The maximum workable slope on a roof is _____ | show 🗑
|
||||
| show | 2:12 or less
🗑
|
||||
| a Roof with a steep slope is also known as a | show 🗑
|
||||
| show | Gusset plates or comparable hardware, Nails are not allowed
🗑
|
||||
| show | They run perpendicular to the rafters and are braced to walls or beams below
🗑
|
||||
| show | 4 feet O.C
🗑
|
||||
| When must a Purlin brace be a 4x4? | show 🗑
|
||||
| show | 8 feet
🗑
|
||||
| show | 1 square feet of opening for every 150 square feet of roof
🗑
|
||||
| What can I use to set rafters without cutting birdsmouths? | show 🗑
|
||||
| show | Structural Metal Roof panels
🗑
|
||||
| Double Top Plates should be nailed together with _________ | show 🗑
|
||||
| show | 20 " x 30"
🗑
|
||||
| The attic area directly above the attic opening should have | show 🗑
|
||||
| A roof with 3:12 pitch or greater and joinst 16" O.C. should have OSB plywood at least ________ | show 🗑
|
||||
| Define a "single ply" roof | show 🗑
|
||||
| When framing walls, what is an acceptable variation in heighths? | show 🗑
|
||||
| U-Shaped Kitchens should have at least __________ between opposing cabinets and countertops | show 🗑
|
||||
| show | 40 inches
🗑
|
||||
| show | #30 felt
🗑
|
||||
| show | 45 to 60 degree
🗑
|
||||
| define a "prowl" | show 🗑
|
||||
| show | 1x the depth of the joist
🗑
|
||||
| show | 1/4 : 12
🗑
|
||||
| Ceiling Joists on top of a 24" spaced wall cannot be more than __________ from a stud | show 🗑
|
||||
| show | Torch Down
🗑
|
||||
| Usually, Deck Joists can cantilever ___________ | show 🗑
|
||||
| show | 1 hour
🗑
|
||||
| show | 4x the joist height
🗑
|
||||
| show | 5/8 inch
🗑
|
||||
| show | multiple layers of room laminated with Asphalt Bitumen or "Torch Down"
🗑
|
||||
| show | #30 asphalt
🗑
|
||||
| What is the minimum slope of a tile roof? | show 🗑
|
||||
| What type of lumber is used in trusses? | show 🗑
|
||||
| show | A rafter going off of a hip running perpendicular to the common rafters
🗑
|
||||
| show | 3/8
🗑
|
||||
| What size plywood should be used on a wall with 16" O.C studs | show 🗑
|
||||
| What are the rules to how holes should be spaced in an I-Joist | show 🗑
|
||||
| What is a Hog Valley? | show 🗑
|
||||
| show | 20 minutes
🗑
|
Review the information in the table. When you are ready to quiz yourself you can hide individual columns or the entire table. Then you can click on the empty cells to reveal the answer. Try to recall what will be displayed before clicking the empty cell.
To hide a column, click on the column name.
To hide the entire table, click on the "Hide All" button.
You may also shuffle the rows of the table by clicking on the "Shuffle" button.
Or sort by any of the columns using the down arrow next to any column heading.
If you know all the data on any row, you can temporarily remove it by tapping the trash can to the right of the row.
To hide a column, click on the column name.
To hide the entire table, click on the "Hide All" button.
You may also shuffle the rows of the table by clicking on the "Shuffle" button.
Or sort by any of the columns using the down arrow next to any column heading.
If you know all the data on any row, you can temporarily remove it by tapping the trash can to the right of the row.
Embed Code - If you would like this activity on your web page, copy the script below and paste it into your web page.
Normal Size Small Size show me how
Normal Size Small Size show me how
Created by:
yobryan2009
Popular Human Services sets