click below
click below
Normal Size Small Size show me how
RADT 456 E.O. & Q.C.
ARRT registry review covering Equipment Operation & Quality Control content area
Question | Answer |
---|---|
Bremsstrahlung radiation make up what percent of the x-ray beam? | 70%-90% pg. 437 |
What percent of the x-ray beam does characteristic radiation make up? | 10%-30% pg. 437 |
Compton scatter ejects an _________ ________ electron. | outer shell pg. 440 |
The number of cycles per unit of time is the definition of __________. | frequency pg. 443 |
The unit of measurement for frequency is _________. | Hertz (Hz) pg. 444 |
Which scientist observed that a magnetic field with induce an electric current? | Faraday pg. 445 |
A singe-phase, full-wave rectified waveform has a ___ % voltage ripple. | 100 pg. 448 |
A three-phase/six-pulse rectification has a ___ % voltage ripple. | 13 pg. 449 |
A three-phase/twelve pulse rectification has a ___ % voltage ripple. | 4 pg. 449 |
The focal track of the anode is made up of what kind of material? | Tungsten and rhenium alloy pg. 451 |
For a single phase unit, heat units can be determined by the equation? | mA X s X kV = HU pg. 454 |
Causes of x-ray tube failure are _________, ________, ________, and _________. | vaporized tungsten, pitted anode, cracked anode, and gassy tube. pg. 455-457 |
This part of the x-ray circuit functions to automatically adjust for any fluctuations in incoming voltage supply and is located on the primary side. | Line voltage compensator pg. 458 |
This part of the x-ray circuit is a system of diodes that is located between the secondary coil of the high-voltage transformer and the x-ray tube. | Rectifiers pg. 461 |
The range of grays a particular digital system is capable of resolving/demonstrating. | Contrast Resolution pg. 466 |
The ratio of light photons at the output phosphor to the number at the input phosphor. | Flux gain pg. 482 |
The ratio of the diameters of the input and output screens squared refers to _________. | Minification gain pg. 482 |
Diminished resolution and contrast at the periphery. | Vignetting pg. 483 |
The thickness of any absorber and the recording that will reduce x-ray beam intensity to one-half its original value. | Half-Value Layer pg. 497 |
Test performed annually that evaluates the consistency of x-ray tube output and should not vary more than 5%. | Reproducibility pg. 497 |