Busy. Please wait.
Log in with Clever
or

show password
Forgot Password?

Don't have an account?  Sign up 
Sign up using Clever
or

Username is available taken
show password

Your email address is only used to allow you to reset your password. See our Privacy Policy and Terms of Service.


Already a StudyStack user? Log In

Reset Password
Enter the associated with your account, and we'll email you a link to reset your password.

Chemical Texturizing

        Help!  

Question
Answer
show A. Ammonia  
🗑
The main ingredient found in an acid wave is: a. sodium hydroxide b. calcium hydroxide c. potassium hydroxide d. glycerol monothioglycolate   show
🗑
The chemical phase of perms involves all of the following EXCEPT: a. applying neutralizer b. applying perm solution c. wrapping hair around the perm tool d. rinsing the perm solution from the hair   show
🗑
To produce large curls, wave formations or body waves it is necessary to use: a. less neutralizer b. less waving lotion c. more waving lotion d. large diameter rods   show
🗑
Which type of perm rod would be used to achieve uniform curls? a. curved b. convex c. straight d. concave   show
🗑
With concave rods hair on both ends must travel farther than hair in the centre to make one complete turn around the rod, creating a: a. larger, looser curl in the centre b. narrow curl throughout the strands c. wider & more spiraling pattern on the ends   show
🗑
In the perm procedure, proper end paper techniques will eliminate crimps or: a. bevels in the hair b. spirals in the hair c. beads on the ends of the hair d. fishhooks on the ends of the hair   show
🗑
Which of the following descriptions identifies end paper placement for bookend technique used during perm wrapping? a. one end paper on top b. one end paper folded in half c. two end papers folded in half d. two end papers, one on top and one on bottom   show
🗑
When using the double-flat end paper technique, the first end paper is positioned under the strand past ends of the hair & the second paper is placed on top of the strand &: a. near scalp b. covering ends of the hair c. slightly past the first end paper   show
🗑
show B. Weaken the curl formation  
🗑
The size of the base and the angle at which the hair is held while wrapping determines the tool position or: a. base size b. roller size c. base control d. tool position   show
🗑
show A. On base  
🗑
show D. Tension may cause breakage  
🗑
Which tool position results in no curl at the scalp and a minimal degree of volume? a. on base b. off base c. half-off base d. underdirected   show
🗑
show D. Position new texture only where it is desired  
🗑
In alkaline waves, the perm solution chemically breaks the: a. porosity of the hair b. medulla of the hair c. strong disulfide bonds d. color molecules in the hair   show
🗑
In addition to tension and perm solution what do acid waves use to perform the processing action? a. heat b. cold c. drying d. alkalinity   show
🗑
Skipping rods when applying perm solution could cause: a. breakage b. frizziness c. loss of all curl d. inconsistent curl formation   show
🗑
show B. Longer processing time  
🗑
show A. Potassium  
🗑
Neutralizer rebonds & restores disulfide bonds in addition to which? a. increase swelling in the cortex b. softens bonds in the new shape c. reduces swelling caused by the alkalinity d. increases the rate at which the perm solution absorbs into the hair   show
🗑
To remove all chemicals after the hair has been neutralized the hair needs to be: a. rinsed b. blotted c. relaxed d. reprocessed   show
🗑
What is considered to be the range of pH for alkaline waves? a. 3.0 to 4.5 b. 5.0 to 6.5 c. 6.9 to 7.2 d. 8.0 to 9.5   show
🗑
The high alkalinity of cold waves causes the hair fiber to soften and: a. swell b. shrink c. become brittle d. become acidic   show
🗑
show C. Stronger curl  
🗑
Which of the following is NOT true about acid perms? a. better for fragile hair b. slower processing time c. create soft, natural curls d. better for use on resistant hair   show
🗑
The more porous hair is: a. the more elastic it is b. the more coarse it is c. the less resistant it is to absorbing perm solution d. the more resistant it is to absorbing perm solution   show
🗑
To equalize the porosity of highly porous hair it may be necessary to use which of the following products: a. prewrap product b. disulfide product c. strong shampoo product d. sodium hydroxide product   show
🗑
Which of the following descriptions does NOT identify the meaning of porosity? a. the hair's ability to stretch b. the hair's ability to retain liquids c. the hair's ability to absorb liquids d. the hair's ability to absorb perming solution   show
🗑
The hair's ability to stretch and return to its original shape is called: a. texture b. density c. porosity d. elasticity   show
🗑
show A. Texture  
🗑
Which of the following could describe what determines the processing time and proper perm solution? a. client's growth pattern b. client's natural hair color c. the size of the applicator bottle d. the texture, elasticity and porosity of the client's hair   show
🗑
show B. Texture  
🗑
What determines the size and shape of the new curl configuration? a. hair color b. perm solution c. perm rod size d. neutralizing solution   show
🗑
Which of the following statements is NOT true? a. hair that has been colored cannot be permed b. avoid perming damaged hair that shows breakage c. do not perm hair if there are scalp abrasions d. never perm hair that has been treated with sodium hydroxide   show
🗑
show C. Previously permed  
🗑
What is applied to a client's hairline prior to a perm service to protect the skin? a. ammonia b. neutralizer c. perm solution d. protective cream   show
🗑
If perm solution comes in contact with the client's eyes or skin which of the following actions should be taken? a. cover the eye with a bandage b. rinse thoroughly with hot water c. rinse thoroughly with cool water d. cover the eye with a warm towel   show
🗑
Proper draping procedures for chemical services accomplish all of the following EXCEPT: a. preventing burns b. preventing skin irritation c. protecting the client's clothing d. place cape between client and chair back   show
🗑
show B. Metallic Salt  
🗑
show D. 30 minutes  
🗑
Prior to performing a preliminary test curl, hair should be shampooed and: a. left wet b. air-dried c. thermally dried d. gently towel-dried   show
🗑
After completing a service it is important to upgrade the client's: a. record card b. release form c. consultation form d. home care products   show
🗑
What is the most likely cause of underprocessed hair? a. rods too small for the desired curl b. hair wrapped too tightly around rods c. perm solution left on the hair too long d. perm solution not left on the hair long enough   show
🗑
What could be the cause of weak or limp curls? a. client's mood b. overprocessing c. underprocessing d. using rods that are too small   show
🗑
Overprocessed hair could be indicated by hair that is: a. oily b. shiny c. curly when wet and frizzy when dry d. frizzy when wet and curly when dry   show
🗑
What could be the cause of a perm not lasting as long as expected? a. overprocessing b. uneven distribution c. excessive stretching d. incomplete neutralization   show
🗑
Hair wound on rods with too much tension may cause which of the following: a. lighter hair color b. unpleasant odor c. darker hair color d. breakage or dryness   show
🗑
show D. Sodium hydroxide  
🗑
show A. Lye relaxers  
🗑
Super strength relaxer is used for which of the following hair conditions? a. fine, porous hair b. color-treated hair c. curly to medium textured hair d. tightly curled, coarse textured hair   show
🗑
show A. Mild  
🗑
A sodium hydroxide relaxer service should not be performed on which of the following hair conditions? a. hair that is short b.fine textured hair c. extremely curly hair d. hair that has been bleached   show
🗑
What product should NOT be applied to hair that has been previously permed with ammonium thioglycolate? a. neutralizer b. conditioner c. metallic salts d. sodium hydroxide   show
🗑
show D. Texture, elasticity and porosity  
🗑
When performing a chemical relaxing procedure on porous hair, choose a product that has: a. no alkaline content b. a lower alkaline content c. a higher alkaline content d. a high acid and alkaline content   show
🗑
show C. Elasticity  
🗑
What is the shape of a tightly curled hair follicle? a. oval b. round c. straight d. elliptical   show
🗑
show D. 85%  
🗑
show C. Fingers  
🗑
During a chemical relaxer procedure, if the hair is tested with the back of the comb & there is minimal amount of indentation, or the curl pattern reverts or beads, what step may be required? a. blotting hair b.rinsing immediately c. additional smoothing   show
🗑
show A. 1/4" to 1/2"  
🗑
An acid-balanced neutralizing shampoo or stabilizer is used after the hair is free of chemicals to: a. smooth the hair b. loosen the shape c. condition the hair d. reharden the hair   show
🗑
What does the porosity of the hair affect when working with a chemical relaxer? a. elasticity b. the hairstyle c. processing time d. the type of relaxer   show
🗑
What is used to protect the scalp and hairline from caustic chemicals? a. sealer b. conditioner c. hand lotion d. protective base cream   show
🗑
show D. Allow it to spread upward toward the scalp  
🗑
show C. Pre-shampoo the client's hair  
🗑
show D. Apply a conditioning treatment  
🗑
Virgin thio relaxers may be applied after all of the following EXCEPT: a. a light shampoo b. a vigorous shampoo c. an analysis of hair and scalp d. a strand test and an elasticity test   show
🗑
show A. Comb test  
🗑
To protect previously treated hair from the chemical product when performing a relaxer retouch service, what should be applied? a. powder b. alkaline product c. protective cream d. neutralizing product   show
🗑
All of the following are terms that describe changing tightly curled hair to curly or wavy hair EXCEPT: a. curl reforming b. relaxer retouch c. reformation curls d. double-process perm   show
🗑
Rearrangers are used during a curl reformation process to reduce the natural curl. What is the main ingredient found in rearrangers? a. hydrogen peroxide b. sodium hydroxide c. ammonium thioglycolate d. glycerol monothioglycolate   show
🗑
During a curl reforming service what size parting should be used? a. wider than normal b. thinner than normal c. twice as wide as normal d. three times as wide as normal   show
🗑
When performing a curl reformation service, the rod diameter chosen should be at least how many times larger than the diameter of the natural curl pattern? a. two b. four c. six d. ten   show
🗑
Thio is an alkaline chemical with a general pH of: a. 3.6 b. 4.5 c. 7.8 d. 9.6   show
🗑
Once the hair is completely wrapped during a curl reformation service, what is applied to ensure thorough saturation of the waving lotion? a. additional oil b. additional booster c. additional moisturizer d. additonal conditioner   show
🗑
show D. Help retain shape of a new curl configuration  
🗑
Why should brushing the hair before any chemical service be avoided? a. prevents scalp irritations b. increases static electricity c. causes the cuticle to flatten d. increases excretion of sebum   show
🗑
If curl reforming is desired, cut off all hair previously treated with which of the following? a. peroxide b. sodium hydroxide c. ammonium thioglycolate d. glycerol monothioglycolate   show
🗑


   

Review the information in the table. When you are ready to quiz yourself you can hide individual columns or the entire table. Then you can click on the empty cells to reveal the answer. Try to recall what will be displayed before clicking the empty cell.
 
To hide a column, click on the column name.
 
To hide the entire table, click on the "Hide All" button.
 
You may also shuffle the rows of the table by clicking on the "Shuffle" button.
 
Or sort by any of the columns using the down arrow next to any column heading.
If you know all the data on any row, you can temporarily remove it by tapping the trash can to the right of the row.

 
Embed Code - If you would like this activity on your web page, copy the script below and paste it into your web page.

  Normal Size     Small Size show me how
Created by: lois100754
Popular Miscellaneous sets